GATE 2002 Production & Industrial

A cup of $$10$$ $$cm$$ height and $$5$$ $$cm$$ diameter is to be made from a sheet metal of $$2mm$$ thickness. The number of deductions necessary will be

In sheet metal working, the spring back increase when $$P:$$ Ratio of bend radius to sheet thickness is small $$Q:$$ Young's modulus of the sheet is low $$R:$$ Yield strength of th...

In spot pulsed laser welding of aluminium plates (density $$ = 2700kg/{m^3},$$ specific heat $$=896J/kg,$$ melting temp $$=933K,$$ latent heat of melting $$ = 398\,\,kJ/kg)$$ at a...

A side and face cutter $$125mm$$ diameter has $$10$$ teeth. It operates at a cutting speed of $$14m/min$$ with a table traverse $$100mm/min.$$ The feed per tooth of the cutter is

A $$31.8MM$$ $$HSS$$ drill is used to drill a hole in cast iron block $$100$$ $$mm$$ thick at cutting speed of $$n20m/min$$ and feed $$0.3min/rev.$$ If the over travel of drill is...

A cutting tool is designated in 'Orthogonal Rake System' as: $$${0^ \circ } - {0^ \circ } - {6^ \circ } - {6^ \circ } - {25^ \circ } - {75^ \circ } - 0.8\,\,mm.$$$ The following da...

Two different tools $$A$$ and $$B$$ having nose radius of $$0.6mm$$ and $$0.33mm$$ respectively are used to machine $$C-45$$ steel employing feed rate of $$0.2$$ $$mm/rev$$ and $$0...

The height of the down sprue is $$175$$ $$mm$$ and its $$CS$$ area at the base is $$200\,\,m{m^2}.$$ The $$CS$$ area of the horizontal runner is also $$200$$ $$m{m^2}$$. Assuming n...

The permeability of molding sand was determined using a saturated $$AFS$$ sample by passing $$2000cc$$ of air at a gage pressure of $$10$$ $$g/c{m^2}$$. If the time taken for the a...

Proper gating design in metal casting $$P:$$ Influences the freezing range of the melt $$Q:$$ Compensates the loss of fluidity of the melt $$R:$$ Facilitates top feeding of the mel...

A $$10$$ $$mm$$ thick steel bar is to be horizontally cast with two correctly spaced top risers of adequate feeding capacity. Assuming end effect without chill, what should be the...