Machine Design - Welded Joints
GATE Mechanical Engineering · 3 questions across 3 years (2021-2026) · 8% recurrence rate
Recurrence sparkline
2021–2026Difficulty mix
Question types
All 3 questions on Machine Design - Welded Joints
A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the figure below. The length of the weld is l and the fillet weld leg size is h. The allowable shear strength of the...
Two plates of thickness 10 mm each are to be joined by a transverse fillet weld on one side and the resulting structure is loaded as shown in the figure below. If the ultimate tensile strength of the weld material is 150...
A cantilever beam of rectangular cross-section is welded to a support by means of two fillet welds as shown in figure. A vertical load of 2 kN acts at free end of the beam. Considering that the allowable shear stress in...