torque

A solid massless cylindrical member of 50 mm diameter is rigidly attached at one end, and is subjected to an axial force P = 100 kN and a torque T = 600 N. m at the other end as sh...

A short shoe drum (radius 260 mm) brake is shown in the figure. A force of 1 kN is applied to the lever. The coefficient of friction is 0.4. The magnitude of the torque applied by...

The torque provided by an engine is given by T(θ) = 12000 + 2500 sin(2θ) N.m, where θ is the angle turned by the crank from inner dead center. The mean speed of the engine is 200 r...

A short shoe external drum brake is shown in the figure. The diameter of the brake drum is 500 mm. The dimensions a = 1000 mm, b = 500 mm and c = 200 mm. The coefficient of frictio...

A single block brake with a short shoe and torque capacity of 250 N·m is shown. The cylindrical brake drum rotates anticlockwise at 100 rpm and the coefficient of friction is 0.25....

A frictionless gear train is shown in the figure. The leftmost 12-teeth gear is given a torque of 100 N-m. The output torque from the 60-teeth gear on the right in N-m is

A single-plate clutch has a friction disc with inner and outer radii of 20 mm and 40 mm, respectively. The friction lining in the disc is made in such a way that the coefficient of...

A rope brake dynamometer attached to the crank shaft of an $$I.C.$$ engine measures a brake power of $$10$$ kW when the speed of rotation of the shaft is $$400$$ rad/s. The shaft t...

Two solid circular shafts of $${{R_1}}$$ and $${{R_2}}$$ are subjected to same torque. The maximum shear stresses developed in the two shafts are $${\tau _1}$$ and $${\tau _2}.$$ I...

Two steel bars each of diameter $$10mm$$ are coaxially friction welded end to end at an axial pressure of $$200MPa$$ and rotational speed of $$400rpm$$. The coefficient of friction...

A journal bearing has a shaft diameter of $$40$$ $$mm$$ and a length of $$40mm.$$ The shaft is rotating at $$20$$ $$rad/s$$ and the viscosity of the lubricant is $$20$$ $$mPa$$-$$s...

A wheel of mass m and radius r is in accelerated rolling motion without slip under a steady axial torque $$T$$. If the coefficient of kinetic friction is $$\mu $$, the friction for...

The yield strength of a steel shaft is twice its endurance limit. Which of the following torque fluctuations represent the most critical situation according to Soderberg criterion?

In order to test the efficiency of reducer gear train $$1kW$$ input was given at the input end at a speed of $$1440$$ $$rpm$$ and at the output end the measured torque was $$56.36$...