tolerances

When assembled, the hole $30^{+0.030}_{+0.000}$ mm and shaft $30^{-0.020}$ mm will result in

When assembled, the hole $$ \begin{array}{r} +0.030 \\ 30+0.000 \end{array} $$. mm and shaft $$ \begin{array}{r} +0.020 \\ 30-0.020 \end{array} $$ mm will result in

The type of fit between a mating shaft of diameter $25.0^{\begin{matrix} +0.010 \\\ -0.010 \end{matrix}}$ mm and a hole of diameter $25.0^{\begin{matrix} +0.015 \\\ -0.015 \end{mat...

A hole is dimension $$\phi {9^{\matrix{ { + 0.015} \cr { + 0\,\,\,\,\,\,\,\,\,\,} \cr } }}\,mm.$$ The corresponding shaft is of dimension $$\phi {9^{\matrix{ { + 0.010} \cr { + 0.0...

What are the upper and lower limits of the shaft represented by $$60{f_8}$$? Use the following data: Diameter $$60$$ lies in the diameter step of $$50-80$$ $$mm$$ Fundamental toler...

The fit on a hole-shaft system is specified as $$H7$$-$$s6.$$ The type of fit is

A shaft of diameter $${20^{\matrix{ { + 0.05} \cr { - 0.15} \cr } }}\,\,mm$$ and a hole of diameter $${20^{\matrix{ { + 0.20} \cr { + 0.10} \cr } }}\,\,mm$$ when assembled would yi...

The hole $${40^{\matrix{ {0.020} \cr { + 0.000} \cr } }}$$ & shaft, $${40^{\matrix{ { + 0.010} \cr { - 0.010} \cr } }}$$ when assembled will result in