shear strength

A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the figure below. The length of the weld is l and the fillet weld leg size is...

In an orthogonal machining operation, the cutting and thrust forces are equal in magnitude. The uncut chip thickness is 0.5 mm and the shear angle is 15°. The orthogonal rake angle...

In a pure orthogonal turning by a zero rake angle single point carbide cutting tool, the shear force has been computed to be 400 N. The cutting velocity, Vc = 100 m/min, depth of c...

In orthogonal turning of a cylindrical tube of wall thickness 5 mm, the axial and the tangential cutting forces were measured as 1259 N and 1601 N, respectively. The measured chip...

In a sheet metal of $$2$$ $$mm$$ thickness a hole of $$10$$ $$mm$$ diameter needs to be punched. The yield strength in tension of the sheet material is $$100$$ $$MPa$$ and its ulti...

A $$60mm$$ long and $$6mm$$ thick fillet weld carries a steady load of $$15kN$$ along the weld. The shear strength of the weld material is equal to $$200MPa.$$ The factor of safety...

The cutting force in punching and blanking operations mainly depends on

In an orthogonal cutting operation on a work piece of width $$2.5mm,$$ the uncut chip thickness was $$0.25$$ $$mm$$ and the tool rake angle was $$0$$(zero) degrees. It was observed...