shear force

A cantilever beam of length L is subjected to a concentrated load P and a moment M as shown in the figure below. Neglecting the mass of the beam, which one of the following options...

During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut chip thickness is 0.23 mm. The shear angle, tangential force component, and radi...

An orthogonal cutting operation is performed using a single point cutting tool with a rake angle of 12° on a lathe. During turning, the cutting force and the friction force are 100...

For a loaded cantilever beam of uniform cross-section, the bending moment (in N·mm) along the length is $M(x) = 5x^2 + 10x$, where x is the distance (in mm) measured from the free...

A steel plate, connected to a fixed channel using three identical bolts A, B and C, carries a load of 6 kN as shown in the figure. Considering the effect of direct load and moment,...

For a loaded cantilever beam of uniform cross-section, the bending moment (in N-mm) along the length is M(x) = 5x 2 +10x, where x is the distance (in mm) measured from the free end...

A rectangular hole of size $$100\,\,mm \times 50\,\,mm$$ is to be made on a $$5$$ $$mm$$ thick sheet of steel having ultimate tensile strength and shear strength of $$500$$ $$MPa$$...

Orthogonal turning is performed on a cylindrical work piece with shear strength of $$250Mpa.$$ The following conditions are used: cutting velocity is $$180m/min,$$ feed is $$0.2mm/...

$$10$$ $$mm$$ diameter holes are to be punched in a steel sheet of $$3$$ $$mm$$ thickness. Shear strength of the material is $$400\,\,N/m{m^2}$$ and penetration is $$40\% $$. Shear...

For a simply supporting beam on two end supports the Bending Moment is maximum: