rolling

A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of 500 mm . The plate thickness is to be reduced to 27 mm in a single pass...

A 4 mm thick aluminum sheet of width w = 100 mm is rolled in a two-roll mill of roll diameter 200 mm each. The workpiece is lubricated with a mineral oil, which gives a coefficient...

The thickness, width and length of a metal slab are 50 mm, 250 mm and 3600 mm, respectively. A rolling operation on this slab reduces the thickness by 10% and increases the width b...

The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls. Neglect elastic deflection of the rolls and assume that the coefficient of...

Match the following products with the suitable manufacturing process

A strip of $$120mm$$ width and $$8mm$$ thickness is rolled between two $$300$$ $$mm$$-diameter rolls to get a strip of $$120mm$$ width and $$7.2mm$$ thickness. The speed of the str...

In a rolling operation using rolls of diameter $$500mm,$$ if a thick plate cannot be reduced to less than $$20mm$$ in one pass, the coefficient of friction between the roll and the...

In a slab rolling operation, the maximum thickness reduction $$\left( {\Delta {h_{\max }}} \right)$$ is given by $$\Delta {h_{\max }} = {\mu ^2}R,$$ where $$R$$ is the radius of th...

In a rolling process, the maximum possible draft, defined as the difference between the initial and the final thickness of the metal sheet, mainly depends on which pair of the foll...

A mild steel plate has to be rolled in one pass such that the final plate thickness is $$2/{3^{rd}}$$ of the initial thickness, with the entrance speed of $$10m/min$$ and roll diam...

In a single pass rolling process using $$410mm$$ diameter steel rollers, a strip of width $$140mm$$ and thickness $$8mm$$ undergoes $$10\% $$ reduction of thickness. The angle of b...

In a single pass rolling operation, a $$20mm$$ thick plate with plate width of $$100mm$$, is reduced to $$18mm$$ thick. The roller radius is $$250mm$$ and rotational speed is $$10$...

The thickness of metallic sheet is reduced from an initial value of $$16mm$$ to a final value of $$10mm$$ in one single pass rolling with a pair of cylindrical rollers each of diam...

In a rolling process, sheet of $$25$$ $$mm$$ thickness is rolled to $$20$$ $$mm$$ thickness. Roll is of diameter $$600$$ $$mm$$ and it rotates at $$100$$ $$rpm.$$ The roll strip co...

A strip with sectional area $$150mm\,\, \times \,\,4.5mm$$ is being rolled with $$20\% $$ reduction of area using $$450mm$$ diameter rollers. The angle subtended by the deformation...

A metal strip is to be rolled from an initial wrought thickness of $$3.5$$ $$mm$$ to a final rolled thickness of $$2.5$$ $$mm$$ in a single pass rolling mill having rolls of $$250$...

Calculate the bite angle when rolling plates $$12mm$$ thick using work rolls $$600mm$$ diameter and reducing the thickness by $$3mm$$

A strip of thickness $$T$$ $$mm$$ is rolled in a $$2$$ high single pass rolling mill, having roll diameter $$D$$ $$mm,$$ to a final thickness of $$\left( {T - 2\Delta T} \right)mm....