machining time

A flat surface of a C60 steel having dimensions of 100 mm (length) x 200 mm (width) is produced by a HSS slab mill cutter. The 8-toothed cutter has 100 mm diameter and 200 mm width...

A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS slab mill cutter. The 8-toothed cutter has 100 mm diameter and 200 mm width...

The length, width and thickness of a steel sample are 400 mm, 40 mm and 20 mm, respectively. Its thickness needs to be uniformly reduced by 2 mm in a single pass by using horizonta...

A circular hole of 25 mm diameter and depth of 20 mm is machined by EDM process. The material removal rate (in mm³/min) is expressed as $4 \times 10^4 IT^{-1.23}$, where I = 300 A...

A block of length $$200$$ $$mm$$ is machined by a slab milling cutter $$34$$ $$mm$$ in diameter. The depth of cut and table feed are set at $$2$$ $$mm$$ and $$18$$ $$mm/minute,$$ r...

The following data is applicable for a turning operation. The length of job is $$900$$ $$mm,$$ diameter of job is $$200$$ $$mm,$$ feed rate is $$0.25$$ $$mm/rev$$ and optimum cutti...

A hole of $$20$$ $$mm$$ diameter is to be drilled in a steel block of $$40$$ $$mm$$ thickness. The drilling is performed at rotational speed of $$400$$ $$rpm$$ and feed rate of $$0...

A $$CNC$$ vertical milling machine has to cut a straight slot of $$10$$ $$mm$$ width and $$2$$ $$mm$$ depth by a cutter of $$10$$ $$mm$$ diameter between points $$(0, 0)$$ and $$(1...

In a single pass drilling operation, a through hole of $$15$$ $$mm$$ diameter is to be drilled in a steel plate of $$50$$ $$mm$$ thickness. Drill spindle speed is $$500$$ $$rpm,$$...

A low carbon steel bar of $$147$$ $$mm$$ diameter with length of $$630$$ $$mm$$ is being turned with uncoated carbide insert. The observed tool lives are $$24$$ and $$12$$ for cutt...

A $$600$$ $$mm$$ $$ \times \,\,30\,\,mm$$ flat surface of a plate is to be finish machined on a shaper. The plate has been fixed with the $$600$$ $$mm$$ side along the tool travel...

Through holes of $$10$$ $$mm$$ diameter are to be drilled in steel plate of $$20$$ $$mm$$ thickness. Drill spindle speed is $$300$$ $$rpm,$$ feed $$0.2$$ $$mm/rev$$ and drill point...

A batch of $$10$$ cutting tools could produce $$500$$ components while working at $$50$$ $$rpm$$ with a tool feed of $$0.25$$ $$mm/rev$$ and depth of cut of $$1$$ $$mm.$$ A similar...

The time taken to drill a hole though a $$25$$ $$mm$$ thick plate with the drill rotating at $$300$$ $$rpm$$ and moving at a feed rate of $$0.25$$ $$mm$$/revolution is