flow rate

In the pipe network shown in the figure, all pipes have the same cross-section and can be assumed to have the same friction factor. The pipes connecting points W, N, and S with poi...

A high velocity water jet of cross section area = 0.01 m² and velocity = 35 m/s enters a pipe filled with stagnant water. The diameter of the pipe is 0.32 m. This high velocity wat...

As per common design practice, the three types of hydraulic turbines, in descending order of flow rate, are

Water flows through two different pipes A and B of the same circular cross-section but at different flow rates. The length of pipe A is 1.0 m and that of pipe B is 2.0 m. The flow...

Three parallel pipes connected at the two ends have flow-rates $$\,\,\,{Q_1},\,\,\,{Q_2},\,\,\,\,$$ and $${Q_3}$$ respectively, and the corresponding frictional head losses are $${...

In a particular mold design, the down sprue has an area of Cross section of $$6.45\,\,c{m^2}$$ where the pouring basin leads into the sprue. The sprue is $$20$$ $$cm$$ long. The re...