cutting force

Under orthogonal cutting condition, a turning operation is carried out on a metallic workpiece at a cutting speed of 4 m/s. The orthogonal rake angle of the cutting tool is 5º. The...

In an orthogonal machining operation, the cutting and thrust forces are equal in magnitude. The uncut chip thickness is 0.5 mm and the shear angle is 15°. The orthogonal rake angle...

An orthogonal cutting operation is performed using a single point cutting tool with a rake angle of 12° on a lathe. During turning, the cutting force and the friction force are 100...

An orthogonal cutting operation is being carried out in which uncut thickness is 0.010 mm, cutting speed is 130 m/min, rake angle is 15° and width of cut is 6 mm. It is observed th...

In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and thrust force are $$500$$ $$N$$ and $$250$$ $$N,$$ respectively. The coe...

Which pair of following statement is correct for orthogonal cutting using a single-point cutting tool? $$P.$$ reduction in friction angle increases cutting force $$Q.$$ Reduction i...

Better surface finish is obtained with a large rake angle because

The main cutting force acting on a tool during the turning (orthogonal cutting) operation of a metal is $$400N.$$ The turning was performed using $$2mm$$ depth of cut and $$0.1mm/r...

In orthogonal turning of a bar of $$100$$ $$mm$$ diameter with a feed of $$0.25$$ $$min/rev,$$ depth of cut of $$4$$ $$mm$$ and cutting velocity of $$90$$ $$m/min,$$ it is observed...

Orthogonal turning is performed on a cylindrical work piece with shear strength of $$250Mpa.$$ The following conditions are used: cutting velocity is $$180m/min,$$ feed is $$0.2mm/...

In orthogonal turning of medium carbon steel, the specific machining energy is $$2$$ $$kJ/m{m^3},$$ the cutting velocity, feed and depth of cut are $$120m/min,$$ $$0.2mm/rev$$ and...

In an orthogonal cutting test on mild steel, the following data were obtained Cutting speed: $$40$$ $$m/min,$$ Depth of cut: $$0.3$$ $$mm,$$ Tool rake angle : $$ + {5^ \circ },$$ C...

The cutting force in punching and blanking operations mainly depends on

Cutting tools are provided with large positive rake angle mainly for