chip thickness ratio

In an orthogonal machining with a tool of $${9^ \circ }$$ orthogonal rake angle, the uncut chip thickness is $$0.2$$ $$mm.$$ The chip thickness fluctuates between $$0.25$$ $$mm$$ a...

For an orthogonal cutting operation, tool material is $$HSS,$$ rake angle is $${22^ \circ },$$ chip thickness is $$0.8$$ $$mm,$$ speed is $$48$$ $$m/min$$ and feed is $$0.4$$ $$mm/...

Orthogonal turning of a mild steel tube with a tool of rake angle $${10^0}$$ is carried out at a feed of $$0.14$$ $$mm/rev.$$ If the thickness of the chip produced is $$0.28mm,$$ t...

An orthogonal turning operation is carried out under the following conditions; rake angle $$ = {5^ \circ },$$ spindle rotational speed $$=400$$ $$rpm,$$ axial feed $$=0.4$$ $$m/min...

During pure orthogonal turning operation of a hollow cylindrical pipe, it is found that the thickness of the chip produced is $$0.5mm.$$ The feed given to the zero degree rake angl...

A single-point cutting tool with $${12^0}$$ rake angle is used to machine a steel work-piece. The depth of cut, $$i.e$$ uncut thickness is $$0.81$$ $$mm.$$ The chip thickness under...

In orthogonal turning of a low carbon steel bar of diameter $$150mm$$ with uncoated carbide tool, the cutting velocity is $$90m/min,$$ The feed is $$0.24mm/rev$$ and the depth of c...

During orthogonal cutting of mild steel with a $$10$$ degrees rake angle tool the chip thickness ratio was obtained as $$0.4.$$ The shear angle (in degrees) evaluated from this dat...

In an orthogonal cutting experiment with a tool of rake angle $$7$$$$deg$$, the chip thickness was found to be $$2.5mm$$ when the uncut chip thickness was set to $$1mm,$$ find the...

In orthogonal machining operation, the chip thickness and the uncut chip thickness are equal to $$0.45mm$$. If the tool rake angle is $$0$$ deg. The shear plane angle is