blanking

A blanking operation is performed on C20 steel sheet to obtain a circular disc having a diameter of 20 mm and a thickness of 2 mm. An allowance of 0.04 is provided. The punch size...

A blanking operation is performed on C20 steel sheet to obtain a circular disc having a diameter of 20 mm and a thickness of 2 mm. An allowance of 0.04 is provided. The punch size...

The percentage scrap in a sheet metal blanking operation of a continuous strip of sheet metal as shown in the figure is ________ (correct to two decimal places).

A rectangular hole of size $$100\,\,mm \times 50\,\,mm$$ is to be made on a $$5$$ $$mm$$ thick sheet of steel having ultimate tensile strength and shear strength of $$500$$ $$MPa$$...

Calculate the punch size in $$mm,$$ for a circular blanking operation for which details are given below. Size of the blank $$25$$ $$mm$$ Thickness of the sheet $$2$$ $$mm$$ Radial...

The shear strength of a sheet metal is $$300MPa.$$ The blanking force required to produce a blank of $$100$$ $$mm$$ diameter from a $$1.54$$ $$mm$$ thick sheet is close to

The force requirement in a blanking operation of low carbon steel sheet is $$5.0$$ $$kN.$$ The thickness of the sheet is $$'t'$$ and diameter of the blanked part is $$'d'.$$ For th...

$$10$$ $$mm$$ diameter holes are to be punched in a steel sheet of $$3$$ $$mm$$ thickness. Shear strength of the material is $$400\,\,N/m{m^2}$$ and penetration is $$40\% $$. Shear...

In blanking operation the clearance is provided on

The cutting force in punching and blanking operations mainly depends on

A $$50$$ $$mm$$ diameter disc is to be punched out from a carbon steel sheet $$1.0$$ $$mm$$ thick. The diameter of the punch should be (Take clearance as $$3\% $$ of sheet thicknes...

For blanking and piercing operations, clearance is provided on the ................... and the ......................... respectively