shape factor

Consider the beam section shown in the figure, with y indicating the depth of neutral axis (NA). The section is only subjected to an increasing bending moment. It is given that y =...

The steel angle section shown in the figure has elastic section modulus of 150.92 cm³ about the horizontal X - X axis, which passes through the centroid of the section. The shape f...

Consider the horizontal axis passing through the centroid of the steel beam cross-section shown in the figure. What is the shape factor (rounded off to one decimal place) for the c...

For the square steel beam cross-section shown in the figure, the shape factor about Z – Z axis is S and the plastic moment capacity is M_p. Consider yield stress f_y = 250 MPa and...

In the theory of plastic bending of beams, the ratio of plastic moment to yield moment is called

The shape of the cross-section, which has the largest shape factor, is

A cantilever beam of length $$l,$$ width $$b$$ and depth $$d$$ is loaded with a concentrated vertical load at the tip. If yielding starts at a load $$P,$$ the collapse load shall b...

The plastic modulus of a section is $$4.8 \times {10^{ - 4}}\,\,{m^3}.$$ The shape factor is $$1.2$$. The plastic moment capacity of the section is $$120$$ $$kN$$-$$m.$$ The yield...