Skip to content
Early access — you're among the first to try PYQLabs. Share feedback

GATE 2012 Civil Engineering

19 questions across 1 session

PYQ 1

Wheat crop requires 55 cm of water during 120 days of base period. The total rainfall during this period is 100 mm. Assume the irrigation efficiency to be 60%. The area (in ha) of...

Irrigation·MCQ·medium·✓ keyed
PYQ 2

The infinite series $$1 + x + {{{x^2}} \over {2!}} + {{{x^3}} \over {3!}} + {{{x^4}} \over {4!}} + ........$$ corresponds to

Engineering Mathematics·MCQ·easy·✓ keyed
PYQ 3

The ratio of actual evapo-transpiration to potential evapo-transpiration is in the range

Hydrology·MCQ·easy·✓ keyed
PYQ 4

A symmetric frame $$PQR$$ consists of two inclined members $$PQ$$ and $$QR$$, connected at $$‘Q’$$ with a rigid joint, and hinged at $$‘P’$$ and $$‘R’.$$ The horizontal length $$PR...

Structural Analysis·MCQ·medium·✓ keyed
PYQ 5

Is an experiment, positive and negative values are equally likely to occur. The probability of obtaining at most one negative value in five trials is

Engineering Mathematics·MCQ·easy·✓ keyed
PYQ 6

In a steel plate with bolted connections, the rupture of the net section is a mode of failure under

Steel Structures·MCQ·easy·✓ keyed
PYQ 7

The annual precipitation data of a city is normally distributed with mean and standard deviation as $$1000$$mm and $$200$$ mm, respectively. The probability that the annual precipi...

Engineering Mathematics·MCQ·easy·✓ keyed
PYQ 8

The solution of the ordinary differential equation $${{dy} \over {dx}} + 2y = 0$$ for the boundary condition, $$y=5$$ at $$x=1$$ is

Engineering Mathematics·MCQ·easy·✓ keyed
PYQ 9

The estimate of $$\int\limits_{0.5}^{1.5} {{{dx} \over x}} \,\,$$ obtained using Simpson's rule with three-point function evaluation exceeds the exact value by

Engineering Mathematics·MCQ·medium·✓ keyed
PYQ 10

A water sample has a pH of 9.25. The concentration of hydroxyl ions in the water sample is

Environmental Engineering·MCQ·easy·✓ keyed
PYQ 11

The eigen values of matrix $$\left[ {\matrix{ 9 & 5 \cr 5 & 8 \cr } } \right]$$ are

Engineering Mathematics·MCQ·easy·✓ keyed
PYQ 12

Which one of the following is categorized as a long-term loss of prestress in a prestressed concrete member?

Reinforced Cement Concrete·MCQ·easy·✓ keyed
PYQ 13

As per $$IS$$ $$456:2000,$$ in the Limit State Design of a flexural member, the strain in reinforcing bars under tension at ultimate state should not be less than

Reinforced Cement Concrete·MCQ·easy·✓ keyed
PYQ 14

If a small concrete cube is submerged deep in still water in such a way that the pressure exerted on all faces of the cube is p, then the maximum shear stress developed inside the...

Fluid Mechanics and Hydraulic Machines·MCQ·easy·✓ keyed
PYQ 15

A simply supported beam is subjected to a uniformly distributed load of intensity $$w$$ per unit length. On half of the span from one end. The length of the span and the flexural s...

Strength of Materials or Solid Mechanics·MCQ·medium·✓ keyed
PYQ 16

The ratio of the theoretical critical buckling load for a column with fixed ends to that of another column with the same dimensions and material, but with pinned ends, is equal to

Strength of Materials or Solid Mechanics·MCQ·easy·✓ keyed
PYQ 17

If a small concrete cube is submerged deep in still water in such a way that the pressure exerted on all faces of the cube is $$p,$$ then the maximum shear stress developed inside...

Strength of Materials or Solid Mechanics·MCQ·easy·✓ keyed
PYQ 18

The following statements are related to bending of beams: $${\rm I}.$$ The slope of the bending moment diagram is equal to the shear force. $${\rm II}.$$ The slope of the shear for...

Strength of Materials or Solid Mechanics·STMT·easy·✓ keyed
PYQ 19

The Poisson's ratio is defined as

Strength of Materials or Solid Mechanics·MCQ·easy·✓ keyed